Initial Unboxing and Frame Assembly
Installation procedures of pressure solar water heater. At first open the packing case and check the accessories. Put the front legs, rear legs, assistant bars all together, three crossarss, tailtocks, 10 brackets and so on in classification that is convenient to operate in operation.
Take the temp bracket out and connect them with each front leg in turn and take the rear side legs out and connect them with the corresponding connecting holes of the temp brackets by bolts and nuts.
Connect the front and the rear legs with the cousins. Then connect the assistant bars with the front and rear legs according to the corresponding connecting hole.
Structural Reinforcement and Water Tank Mounting
Then connect the rear middle leg with a tank bracket and the front legs with the rear legs by your system bars. Then connect crossarss with the two rear legs that are connected just now. The crossarss can fasten the rear legs. Well, then connect the front legs with the rear middle legs by short assist or system bars.
Connect the tailtock with a corresponding hose of the front legs. Open the front tank pack and screw the nuts down from the connection bolts of the water tank. Put the water tank on the tank brackets slowly and tightly according to the corresponding connecting hose and screw the nuts that have just been screwed down but should be not screwed tightly so as to adjust the angle of water tank and frames in installing vacuum tubes.
Vacuum Tube Installation and Finalization
Firstly, apply heat conducting silicon grease to the condensing end of the tube and shift the antidust circles into the vacuum tubes from the nozzle and then insert the condensing end of the inner tube into the water tank's heat conducting sleeves. run in the tail seat retention ring at the tail end of the heat pie vacuum tube and feed a tail seat retention ring to the lower horizontal linkage rod. Then feed a tail seat adjusting ring to the retention ring by turning the former. While turning, apply appropriate force to lift the heater pipe vacuum tube upward so that there is no room for it to move up down.
At last, fasten all screw. Hope you enjoy sunshine and enjoy life with an Sun Solo. If having any questions, welcome to Contas.
| Feature | Detail |
|---|---|
| Heater System Type | Pressurized Solar Water Heater |
| Collector Technology | Evacuated Tube (Heat Pipe type implied by "heat conducting sleeves", "condensing end", "heat pie vacuum tube") |
| Installation Method | Frame-based (using front legs, rear legs, assistant bars, crossbars, brackets) |
| Tube Sealing | Antidust circles, Tail seat retention/adjusting rings |
| Heat Transfer Aid | Heat Conducting Silicon Grease |
| Water Tank Interface | Heat Conducting Sleeves, Connection Bolts |
| Fasteners | Bolts and Nuts, Screws |
Frequently Asked Questions
Q1: What is the very first step in installing a pressure solar water heater?
A1: The very first step is to open the packing case and thoroughly check all the included accessories. Afterward, you should classify components such as front legs, rear legs, assistant bars, crossbars, tailstocks, and brackets to organize them for easier operation.
Q2: How are the vacuum tubes properly secured into the water tank?
A2: To secure the vacuum tubes, first apply heat conducting silicon grease to the condensing end of each tube. Then, shift the antidust circles into the vacuum tubes from the nozzle. Insert the condensing end of the inner tube into the water tank's heat conducting sleeves. Finally, secure them by running in the tail seat retention ring at the tail end of the tube and feeding a tail seat adjusting ring to the retention ring, turning it while applying force to lift the tube upward until it is snug.
Q3: Why should the water tank's connection nuts not be fully tightened immediately after placing the tank?
A3: The nuts from the connection bolts of the water tank should not be screwed tightly immediately. This is crucial to allow for adjustment of the angle of both the water tank and the frame components. This adjustability is necessary during the subsequent installation of the vacuum tubes to ensure proper alignment before final fastening.